Sample Page Title

For FPV pilots, stick instructions are an important software for altering settings of your flight controller or FPV system instantly out of your radio. These instructions mean you can carry out varied capabilities, from navigating the OSD menu to trimming accelerometer, making them invaluable while you’re within the subject with out entry to a pc. I’ll share the the stick instructions diagrams for Betaflight, iNav, and HDZero, so that you don’t must memorize them.

A number of the hyperlinks on this web page are affiliate hyperlinks. I obtain a fee (at no additional price to you) if you happen to make a purchase order after clicking on one in every of these affiliate hyperlinks. This helps assist the free content material for the group on this web site. Please learn our Affiliate Hyperlink Coverage for extra info.

What Are Stick Instructions?

Stick instructions are particular mixtures of joystick actions in your radio that ship instructions to the flight controller (FC), enabling sure capabilities or activating the OSD menu.

Be aware: All stick command diagrams on this information use Mode 2, the most well-liked radio configuration. In the event you use a distinct mode, you’ll want to regulate the diagrams accordingly.

What’s Mode 2?
In Mode 2, the left stick controls throttle and yaw, whereas the proper stick controls pitch and roll. Study in regards to the fundamentals of radio right here: https://oscarliang.com/radio-transmitter/#Modes

Betaflight Stick Instructions

Essentially the most generally used Betaflight stick instructions embody:

• Enter OSD Menu: Maintain yaw left and pitch ahead.
• Accelerometer (ACC) Calibration: Maintain throttle up, yaw left, and pitch backward. That is helpful if you happen to can’t carry out ACC calibration on a bench utilizing the configurator.
• Trim ACC: Use the 4 ACC trim instructions to regulate errors within the accelerometer. That is significantly useful in case your quad drifts in Angle or Horizon mode or if you happen to calibrated the ACC on an uneven floor.

Professional Tip: Guarantee you might have full stick journey to entry these instructions. Your stick endpoints ought to ideally be at 1000 and 2000, with the middle at 1500. If for no matter cause you possibly can’t get to those numbers, Betaflight permits you to change these values within the Receiver tab, simply alter the “Stick Low,” “Stick Middle,” and “Stick Excessive”. However for most individuals the default values ought to work high quality and don’t want altering.

iNav Stick Instructions

Most iNav stick instructions are just like Betaflight’s since each tasks originated from Cleanflight. Nevertheless, iNav introduces further instructions for navigation-focused capabilities:

• Load and Save Waypoint Missions: Distinctive to iNav, these instructions allow you to load or save pre-planned missions by way of the OSD menu with no need a pc.
• Compass Calibration: Throttle down, yaw proper, and roll left. You may use this command extra usually in iNav than Betaflight, particularly earlier than GPS-assisted flights to make sure correct navigation.

HDZero Stick Instructions

HDZero FPV system features a collection of stick instructions for its video and OSD menu. These embody:

• Enter the HDZero OSD Menu: Entry and alter settings particular to HDZero.
• Video Output Mode Change: Swap output modes to regulate show preferences.

Conclusion: Why Stick Instructions Matter

Utilizing stick instructions in Betaflight, INAV, and HDZero unlocks a stage of comfort and management that enhances your general flight expertise. These instructions enable for fast tweaks with no need a pc, making them important within the subject.